Advertisement
Turd the cert right side up to rests on its wheels.
Place the engine assembly (blower housing to the
front) onto the welded angles of the tongue, aligning
the holes in the engine base with the holes in the
welded angles. See figure 12.
•
Secure the engine base assembly to the welded
angles using four 3/8" x 1" hex bolts, 3/8" Iockwash-
ers and 3/8" hex lock nuts. See figure 12. 13ghten all
nuts and bolts securely.
NOTE:
Make sure engine is positioned with blower
housing to the front.
ENGINE
BASE
ASSEMBLY
3/8-16 x 1"
HEX BOL
WELDED ANGLES
ON TONGUE
m=,_=
"_
FRONT
3/8" HEX NUT
3/8" LOCK
WASHER
FIGURE 12
•
Placea comer cap over each front comer of the cart
as shown in figure 13.
CORNER CAPS
FIGURE 13
Position a side panel on top of the cart bed flange and
front corner cap. Align holes in side panel with holes
in comer cap and holes in top of cart bed flange.
Fasten together using two 1/4" x 3/4" hex bolts, two
1/4" fiat washers, two 1/4" lock washers and two 1/4"
hex nuts. Repeat for other side. See figure 14.
SIDE PANELS
LOCK
WASHER
1/4" HEX NUT
FIGURE 14
10
Advertisement
