Advertisement
Table of Contents
CONTAINER
ASSEMBLY
(See Fig. 3)
1.
Place bottom half inside of top half, as shown.
2.
Place one foot inside bottom half and lift top haft to
meet bottom half.
3.
Press halves tightly together while lifting top to lock
into place as shown.
IMPORTANT:BEFORE LOCKING THETABS, HOOKED EDGES
ON BOTH HALVESMUSTOVERLAPTO FORMSEALAS SHOWN
IN INSET.
4.
Repeat for other containers.
CONTAINER
Bo'rroM
HALF
CONTAINER
TOP HALF
PRESSTOGETHER
TO FORM SEAL
CONTAINER
WHILE LIFTING
TOP HALF
TOP HALF
CONTAINER
BoTroM
HALF
LOCKING
TAB
FIG. 3
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves.
If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
CONTAINER
MOUNTING
(See Fig. 4)
Install one container to left side first with warning to
outside of unit. Install another container
to center
position and one in right position.
NOTE: Right container should always overlap left container
at center supports.
Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
_ENTER
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING
6
Advertisement
Table of Contents
