(See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
Position cover assembly on ground behind tractor.
Lift and rotate coverto align cover brackets with support
Slide cover assembly down onto the support tubes.
(See Fig. 3)
half inside of top half, as shown.
Place one foot inside
half and lift top half to
lifting top to lock
into place as shown.
iMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES
ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS
SHOWN IN INSET
Repeat for other containers.
TO FORM SEAL
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
If a gap appears, unlock tabs to separate
container halves and repeat instructions above.