TOOLs rEquIrEd FOr assEMBLy
(2)
7/16" wrenches
(2)
9/16" wrenches
(1)
3/4" wrench
CauTION! Muffler is hot! Allow engine to
cool down before proceeding with bumper
installation.
sTEp 1:
(sEE FIGurE 1)
•
Slide the ends of the latch into the slots located on
the bottom of the bumper.
•
Push the front of the latch down past plastic shroud
of bumper. Latch will be under the shroud and
should appear as shown in figure 3 when assembled
correctly.
•
Attach one spring onto the rod on each side of the
latch.
FIGurE 1
4
assEMBLy
LATCH
SPRING
sTEp 2:
(sEE FIGurE 2)
•
Insert 1/4 x 1-1/4" hex bolt through one of the springs.
•
Assemble 1/4 x 1-1/4" hex bolt onto the bumper using
two 1/4-20 hex nuts (SIMS) with end of bolt extending
slightly through outside nut.
•
Repeat for spring on other side.
1/4" HEX
NUT (SIMS)
FIGurE 2
sTEp 3:
(sEE FIGurE 3)
•
Assemble a 3/8 x 1" hex bolt, 3/8" washer, frame
brace and 3/8" lock nut to the rear hole of the bumper.
FIGurE 3
Call 1-866-576-8388 for missing parts or assembly help
1/4" HEX
NUT (SIMS)
1/4 x 1-1/4"
HEX BOLT
SPRING
3/8 x 1"
HEX BOLT
3/8" WASHER
FRAME
3/8" LOCK NUT
BRACE
DO NOT RETURN TO STORE