Installing A Hot-Swap Power Supply - Lenovo ThinkServer TD200x Installation And User Manual

To remove a hot-swap power supply, do the following:
1. Read the safety information "Safety" on page vii and "Handling static-sensitive
2. Disconnect the power cord from the connector on the back of the power supply
3. Press the release latch on the power supply 1 and pull the power supply 2
4. If you are instructed to return the hot-swap power supply, follow all packaging

Installing a hot-swap power supply

If you install or remove a hot-swap power supply, observe the following precautions.
Statement 8:
64
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide
devices" on page 39.
Attention: Static electricity that is released to internal server components
when the server is powered on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
that you are removing.
out of the power-supply cage.
instructions, and use any packaging materials for shipping that are supplied to
you.