Removing An Adapter; Installing An Adapter - Lenovo ThinkServer TD200x Installation And User Manual

(english) installation and user guide
Hide thumbs Also See for ThinkServer TD200x:
Table of Contents

Advertisement

Removing an adapter

To remove an adapter, do the following:
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on
5. Rotate the adapter retention brackets to the open position.
6. Disconnect the cables from the adapter.
7. Remove the screw that secures the adapter to the server chassis.
8. Pull the adapter out of the adapter connector; then, lift the adapter out of the
9. If you are instructed to return the adapter, follow all packaging instructions, and

Installing an adapter

The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
72
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide
1
Rear adapter retention bracket
2
Adapter
3
Front adapter retention bracket
static-sensitive devices" on page 39.
all external cables.
up.
Attention:
Do not allow the server to fall over.
page 42).
server.
use any packaging materials for shipping that are supplied to you.

Advertisement

Table of Contents
loading

Table of Contents