Lexmark T652 Service Manual page 65

Error
code or Error contents
message
202.99 Fuser ID chip failure
203.00 Paper jam around
redrive area.
203.01 Internal duplex drive
motor control failure.
Internal duplex
203.08 Redrive motor load
error
Description/Action
The system does not recognize
the ID chip on the fuser unit.
Page may be jammed in
redrive area.
The internal duplex drive motor
motor does not reach the
proper operating speed at the
specified time.
The redrive motor assembly
has failed or caused high
mechanical load during the
warm up sequence.
Possible repair actions
Replace the fuser unit
assembly.
Go to "Fuser unit assembly
removal (T650, T652, T654)"
on page 4-23,
1. Remove all media present
in media path.
2. Check media for proper
installation.
3. Check for obstructions in
media path.
4. Go to sensor (fuser output)
service check. See
"Sensor (fuser output)
service check" on
page 2-126.
5. Go to sensor (narrow
media) service check. See
"Sensor (narrow media)
service check" on
page 2-127.
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex media
entrance drive motor
assembly if problem
remains. Go to "Duplex
drive motor assembly
removal (T652, T654)" on
page 4-19.
1. Remove all media present
in media path.
2. Ensure that upper redive
assembly is properly
installed.
3. Check all connections on
the redrive motor assembly.
4. Check all connections on
the system card assembly.
5. Replace the redrive motor
assembly if problem
remains. Go to "Redrive
assembly removal (T650,
T652, T654)" on
page 4-62.
Diagnostic information
4062
2-31