Lexmark T652 Service Manual page 44

4062
Error
code or
message
56
56
56
58
58
2-10
Service Manual
Error contents
Serial Port [x]
Disabled
Standard USB Port
Disabled
USB Port [x] Disabled
Invalid Tray
Configuration
Too Many Bins
Attached
Description/Action
This error displays when data
is sent to the printer across an
serial port, but the port has
been disabled. Once this
message displays, reporting of
further errors is suppressed
until the menus are entered, or
the printer is reset.
Displayed when status is
requested over the USB port,
but the port has been disabled.
Once the error has been
displayed for the first time,
reporting of further errors is
suppressed until the menus are
entered or the printer is reset.
Displayed when status is
requested over the USB port,
but the port has been disabled.
Once the error has been
displayed for the first time,
reporting of further errors is
suppressed until the menus are
entered or the printer is reset.
Either no input trays or there
are optional trays above the
RFID option.
This error code displays when
too many bins are attached to
the printer.
Possible repair actions
Go to network service check.
See "Network service check"
on page 2-177.
The following actions may be
taken:
• Press to clear the
message. The printer
discards any data received
on the USB port.
• Press until Busy/
Waiting appears. The
following are available:
- Reset Printer
Reset Active Bin
The following actions may be
taken:
• Press to clear the
message. The printer
discards any data received
on the USB port.
• Press until Busy/
Waiting appears. The
following are available:
- Reset Printer
Reset Active Bin
1. Ensure the RFID option is
in first position under printer
and that there is at least
one input tray beneath the
RFID option.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
"High
installation. Go to
capacity input tray (HCIT)
pick arm bracket
assembly removal" on
page 4-130.
3. Replace the RFID UHF
option.
1. Turn off and unplug the
printer.
2. Remove the excess bins.
3. Plug in the printer, and turn
it on.