Lexmark T652 Service Manual page 38

4062
Error
code or
message
35
37
2-4
Service Manual
Error contents
Res Save Off
Deficient Memory
Insufficient Collation
Area
Description/Action
This IR is displayed when the
printer lacks sufficient memory
to enable Resource Save. This
message usually indicates the
user has allocated too much
memory for one or more of the
printer's link buffers; however,
modification of other printer
settings which affect the
amount of available memory
may also create this condition.
If the user desires to enable
Resource Save after this
message has been posted, it is
recommended the user either
install additional memory or set
each link buffer back to the
Auto value.
Once all link buffers are
returned to Auto, the user
should exit the menus to
activate the link buffer
changes. Once the printer
returns to the Ready state, the
user may then enable
Resource Save and then finally
go back and modify the link
buffers again. The user should
note the reduction of available
memory to the link buffers
when Resource Save has been
enabled as opposed to the
memory available when
Resource Save is disabled.
This message displays when
the printer memory is
insufficient to perform the Flash
Memory Defragment operation.
Note: This message is posted
prior to the actual start of the
defragment operation. The
printer code determines if
enough printer memory is
available to complete the
defragment operation. The
user should not be concerned
with losing resources stored in
the flash option.
Possible repair actions
This message displays when
the printer lacks sufficient
memory to enable Resource
Save. This message usually
indicates the user has
allocated too much memory for
one or more of the printer link
buffers; however, modification
of other printer settings which
affect the amount of available
memory may also create this
condition. If restoration of
Resource Save is required
after this message is received,
the customer should install
additional memory or set each
link buffer to Auto. Once all link
buffers are returned to Auto,
you should exit the menu to
activate the link buffer
changes. Once the printer
returns to the Ready state, you
can enable Resource Save and
go back and modify the link
buffers again. Note the
reduction of available memory
to the link buffers when
Resource Save has been
enabled, and compare it to the
memory available when
Resource Save is disabled.
• Press to disable
Resource Save and
continue printing.
To enable Resource Save
after you get this message:
- Make sure the link
buffers are set to Auto,
then exit the menus to
activate the link buffer
changes.
- When Ready is
displayed, enable
Resource Save.
• Install additional memory.
The following actions may be
taken:
• Press to clear the
message. To perform the
defragment operation:
- Delete fonts, macros,
and other data in RAM.
- Install additional printer
memory.
• Press until Busy/
Waiting appears. The
following actions are
available:
- Cancel Job
- Reset Printer
- Reset Active Bin