Device Tests - Lexmark Optra W810 Service Manual

4023-001
The second segment (bottom line) contains fifteen bits. Starting from
the left-most bit, the fifteen bits correspond to the following sensors:
1. Bin 3 Empty
2. Bin 2 Empty
3. Bin 3 Full
4. Bin 2 Full
5. Bin 1 Full
6. Bin 10 Empty
7. Bin 9 Empty
8. Bin 8 Empty
9. Bin 9 Full
10. Bin 8 Full
11. Bin 7 Full
12. Bin 6 Full
13. Bin 5 Full
14. Bin 4 Full
15. Bin 10 Full

Device Tests

Quick Disk Test
This test performs a non-destructive read/write on one block per
track on the disk. The test reads one block on each track, saves the
data, and proceeds to write and read four test patterns to the bytes
in the block. If the block is good, the saved data is written back to the
disk.
1. Enter the Diagnostic mode. See
page 3-1.
2. Select [DEVICE TESTS].
3. Select [Quick Disk Test].
– The power indicator blinks while the test is in progress.
– "Quick Disk Test/Test Passed..." message displays if the test
passes and the power indicator turns on solid.
– "Quick Disk Test/Test Failed..." message displays if the test
failed and the power indicator turns on solid.
4. Press Go, Return, or Stop to return to the Device Tests menu.
"Diagnostics Mode" on
Diagnostic Aids
3-19