Lexmark Optra W810 Service Manual page 121

4023-001
Message
34 Wrong Paper
Size in Tray x
35 Res Save Off
Deficient Memory
37 Insufficient
Collation Area
37 Insufficient
Defrag Memory
Description
Install correct paper
size.
The printer lacks the
memory needed to
enable Resource Save.
This message usually
indicates that too much
memory is allocated for
one or more of the
printer link buffers.
This message is
displayed when the
printer memory used to
store pages is too full to
collate the print job.
Action
Check paper size detection
board.
• Tray 1–PWB-S1
• Tray 2,3–PWB-S2
Replace if necessary.
Replace printer main
engine board (PWB-A) if
necessary.
• To enable Resource
Save after this message
is displayed, either
install additional memory
or set each link buffer to
the Auto value.
• After you set all link buff-
ers to Auto, exit the
printer menus to activate
link buffer changes.
• When Ready is dis-
played, enable
Resource Save in the
Setup Menu and modify
the link buffers again.
• Press Go to clear the
message. The printer
automatically disables
Resource Save and
continues.
• Press to print the
Go
portion of the job already
stored and begin collat-
ing the rest of the job.
• Cancel the print job.
Press
Menu>
The Job Menu is dis-
played. Press
until Cancel Job
<Menu
appears on the second
line. Press
See operator manual.
Diagnostic Information
or .
<Menu
or
Menu>
.
Select
2-13