Hard Drive Cage Option - HP ProLiant DL388 User Manual

Hard drive cage option

Installation of a SAS expander card or an additional SAS controller option is required to support the hard
drive cage option.
Power down the server (on page 24).
1.
Extend the server from the rack (on page 24).
2.
Remove the access panel (on page 25).
3.
Disconnect and remove the optical drive cables
4.
Using a T-15 Torx screwdriver, remove the two optical drive retaining screws, and then remove the
5.
optical drive cage.
Remove the two primary hard drive retaining screws, and then slide the primary hard drive cage
6.
forward.
Install the optional hard drive cage.
7.
("Optical drive cabling" on page 69), if installed.
Hardware options installation 64