Hardware Options Installation; Introduction; Processor Option - HP ProLiant DL388 User Manual

Hardware options installation

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options and
identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.

Processor option

The server supports single- and dual-processor operation.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
processor without using the processor installation tool.
CAUTION:
configurations must contain processors with the same part number.
IMPORTANT:
installing the processor.
To install the component:
Power down the server (on page 24).
1.
Extend the server from the rack (on page 24).
2.
Remove the access panel (on page 25).
3.
If any full-length expansion boards are installed, complete the following steps:
4.
Remove the full-length expansion board retainer (on page 28).
a.
Remove the PCI riser cage (on page 29).
b.
Remove the air baffle (on page 31).
5.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To avoid damage to the processor and system board, only authorized personnel
To help avoid damage to the processor and system board, do not install the
To prevent possible server malfunction and damage to the equipment, multiprocessor
If installing a processor with a faster speed, update the system ROM before
Hardware options installation 39