HP ProLiant DL388 User Manual page 13

Secondary Primary
(slot - form factor) (slot - form factor)
1 - FL/FH
4 - FL/FH
2 - HL/FH
5 - LP
3 - HL/FH
6 - LP
Notes:
•
"Primary" denotes the risers are installed in the primary riser connector.
•
"Secondary" denotes the risers are installed in the secondary riser connector.
•
Installing the risers listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those risers.
•
FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
•
The PCIe2 x16 riser supports a maximum power of 150 W with an HP power cable. This cable must be
used for PCIe card wattages greater than 75 W.
PCIe2 riser PCIe2 x16 riser
slot description slot description
PCIe2 x16 (8,4,1) PCIe2 x16
(16,8,4,1)
PCIe2 x8 (4,1) —
PCIe2 x8 (4,1) —
PCIe2/PCI-X riser
slot description
PCI-X 64 bit/133 MHz
PCIe2 x16 (8,4,1)
PCIe2 x8 (4,1)
Component identification 13