Disk; Formatting Disks; Overwrite; Disk Monitor - Digimerge Touch DH200 Series Instruction Manual

Using the Main Menu

DISK

Figure 19.2 Disk menu
Use the Disk menu to format the internal HDD,
external USB flash drive (not included),
external USB HDD, and configure Overwrite
and Disk Monitor settings.

Formatting Disks

ATTENTION:
You must stop all recording
before attempting to format the internal HDD.
To format the internal HDD/external HDD/USB
flash drive:
1. Under the DISK tab, select
select
Internal HDD, USB HDD,
.
Memory Stick
2. Under ACTION, select
begins. Once formatting is complete the
system will reset (internal HDD
3. Press
CANCEL/ESC
only
flash drive ).
30
and
FORMAT
or
USB
. Formatting
START
only
).
to close windows (USB

Overwrite

Disk overwrite will overwrite the oldest data on
the internal HDD once it full.
To enable/disable disk overwrite:
1. Under the DISK, select
select . If OFF, the system will stop
ON/OFF
recording once the HDD is full.
By default, the system is set to
NOTE:
overwrite.
2. Press the button to save your
ENTER
settings.

Disk Monitor

If enabled, Disk Monitor will alert you if the
internal HDD fails.
To enable/disable disk monitoring:
1. Under the DISK tab, select
2. Press the
CANCEL/ESC
and
OVERWRITE
.
START/STOP
button close.