Network; Projector Name; Network Setup; Network Control - Panasonic PT-EZ570UL Operating Instructions Manual

Network

Select [Network] from the Main Menu (see
"Navigating through the menu" on page 47),
then select the item from the sub-menu.
Remote Control

Projector name

You can change the projector name to be displayed
on the network.
1 ) Press ▲▼ to select [Projector name].
2 ) Press the <ENTER> button.
3 ) Press ▲ ▼◄► buttons to set the
[Projector name].

Network setup

You can make detailed wired LAN settings.
1 ) Press ▲ ▼ to select [Network setup],
and press <ENTER> button.
2 ) Press ▲ ▼ to select an item, and
change the setting according to the
instructions.
On: If a DHCP server exists in the
DHCP
Off: If a DHCP server does not
(DHCP client function)
IP address
Enter the IP address if DHCP
(Display of IP address
server is not used.
and setting)
Subnet mask
If not using a DHCP server,
(Displaying and
setting the subnet
enter the subnet mask
)
mask
Side Control
network to which the projector
is connected, the IP address
will automatically be acquired.
exist in the network to which
the projector is connected,
additionally set [IP address,
[Subnet mask] and [ Default
gateway].
Default gateway
Enter the gateway address if DHCP
(Display of gateway
server is not used.
address and setting)
DNS1
(Display of Preferred Enter the DNS server address if
DNS server address DHCP server is not used.
and setting)
DNS2
(Display of Alternate Enter the alternate DNS server
DNS server address address if DHCP server is not used.
and setting)
3 ) Press ▲ ▼◄► to select [Set], and press
<ENTER> button.
Default wired LAN settings
z
The following settings are set before the
projector leaves the factory.
DHCP
IP address
Subnet mask
Default gateway
DNS 1/DNS 2
Note
Before using the DHCP server, make sure the DHCP
z
server is already functioning.
For details of IP address, subnet mask, gateway and
z
DNS, ask the network administrator

Network control

Set when you want to control the projector from a
computer connected to the network.
1 ) Press ▲ ▼ to select [Network control].
2 ) Press ► or the <ENTER> button to
access the submenu items.
3 ) Press ▲ ▼ to select one item and press
◄► to switch the function between
[On] and [Off].
Set to [On] to control with the Web
WEB control
browser.
Set to [On] to control with the
PJLink control
PJLink protocol.
Set to [On] to control with the
Command
SERIAL IN terminal control
control
command format.
Set to [On] to control with the
AMX D. D.
AMX Device Discovery.
Set to [On] to control with the
RoomView
Crestron RoomView
Off
192.168.10.100
255.255.255.0
192.168.10.1
NONE
.
.
®
ENGLISH -
73