Table of Contents
Advertisement
How to use network function (optional)
The input module (ET-MD77NT, ET-MD77DV, ET-MD77SD1 or ET-MD77SD3) available as an optional accessory
comes with a network function to enable the projector to be controlled from the Web browser of the personal
computer.
In addition, the network function also fulfills automatic E-mail transmission function. It can send mail to a
predefined E-mail address when the system malfunctions or when the lamp used hours reaches the set value.
Example of connection
A LAN cable is required to use the network function.
PC
• A Web browser is required to use this function. Make sure that a Web browser is available in the system.
• Use Microsoft Windows 98SE/Me/NT4.0/2000/XP for the OS of your personal computer.
• The Web browser should be Internet Explorer 6.0 or later or Netscape Communicator 7.0 or later.
• To use the E-mail function, communication with E-mail server must be established. Make sure that E-mail
feature is available in your system.
• Use a straight insulated LAN cable which supports category 5 or above.
• The length of LAN cable must be 100 m or shorter.
Name and function of network function parts
LAN10/100 lamp (yellow)
This lights when a 100Base-TX connection is
established.
Attention
• If the LAN terminal is touched by electrostatically charged hands (or body), failure may be caused by the
discharge of static electricity.
Be careful not to touch metallic part of LAN terminal or LAN cable.
84
LAN cable (straight)
Network Module
ET-MD77NT
LAN cable (straight)
Hub
LAN terminal (10 Base-T/100 Base-TX)
Connect LAN cable here.
LAN
Projector
LAN LINK/ACT lamp (green)
This lights when a LAN cable is
connected and flashes when signals are
being received or sent.
Advertisement
Table of Contents
