Simple Mode; Remote Control; Rc Sensor; English - Panasonic PT-EZ570UL Operating Instructions Manual

Simple mode

This function decides whether to activate the simple
mode.
1 ) Press ▲▼ to select [Simple mode] and
then press the <ENTER> button.
2 ) Press ▲▼ to switch between [On] and
[Off].
On
Simple mode function is off.
Only the simple mode buttons
Off
are active.
Only these buttons are active
when the simple mode is set to
[On]. [POWER ON, STANDBY,
SHUTTER (AV MUTE), INPUT,
MENU, AUTO PC ADJ, ▲, ▼
(MUTE), ◄ (VOLUME-), ►
(VOLUME+), ENTER, IMAGE
SELECT, IMAGE ADJUST,
P-TIMER, ECO, SCREEN, P IN
P, ON /OFF]. Number buttons
also become active only when
setting the remote control codes
numbers or entering the PIN
code numbers.
Note
Warning icon and [Simple mode : On] message
z
appear on the screen for about 4 seconds when
press the button which is not the simple mode
button.

Remote control

This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
1 ) Press ▲▼ to select [Remote control].
2 ) Press the <ENTER> button.
3 ) Press ▲▼ to select one among the
sixty and five codes.
This projector provides 65 different remote
z
control codes: [All], [Code 01]~[Code 64].
Note
When operating the projector under [All] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.

RC sensor

Select a location of the infrared remote receiver of the
remote control.
1 ) Press ▲▼ to select [RC sensor].
2 ) Press ► or the <ENTER> button.
3 ) Press ▲▼ to select one among
options as below.
All Activate all of the receivers.
Front & Activate both the front and top
Top
receivers.
Top &
Activate both the top and back
Back receivers.
Front & Activate both the front and back
Back receivers.
Front Activate only the front receiver.
Top Activate only the top receiver.
Back Activate only the back receiver.

Eco management

Can optimize lamp power and reduce the power
consumption according to the application.
1 ) Press ▲▼ to select [Eco
management].
2 ) Press ► or the <ENTER> button.
Auto power save
J
1 ) Press ▲▼ to select [Auto power save]
and press the <ENTER>button.
2 ) Press ▲▼ to choose [On] between
[On] and [Off].
3 ) Press ▲▼ to select auto power save
conditions.
Ambient light Adjusts the lamp power according
detection to the ambient brightness.
Signal Drops the lamp power when no
detection
signal is input.
AV mute
Drops the lamp power in the AV
detection* 1 mute mode.
*1 : This function is only for EW530 series and
EX500 series.
Note
When [Auto power save] is [Off], [Ambient light
z
detection], [Signal detection] and [AV mute detection] are
not available.
Setting
67

ENGLISH -