Rear Terminals - Panasonic PT-EZ570UL Operating Instructions Manual

Rear terminals

(1)
(1) Remote control signal receiver (Back)
The infrared remote receiver is also located in the
front and top.
(2) LAN
Connect the LAN cable.
(3) MONITOR OUT
This terminal can be used to output the incoming
analog RGB signal from INPUT 1-3 terminals to the
other monitor.
(4) RGB
Connect the computer (or RGB scart) output signal to
this terminal.
(5) AUDIO IN 1
Connect the audio output (stereo) signal from a
computer or video equipment to INPUT 1 terminals.
(6) REMOTE IN
When using the wired remote control, connect the
wired remote control to this jack with a remote control
cable (not supplied).
(7) HDMI
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from computer
to this terminal.
(8) DVI-D
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected.
(9) INPUT 2
Connect the component or composite video output
signal from video equipment to VIDEO/G/Y, and R/
P jacks or connect the computer output signal (5
R
BNC Type [Green, Blue, Red, Horiz. Sync, and Vert.
Sync.]) to VIDEO/G/Y, B/P
jacks.
(2) (3)
(4)
(9) (10)
(11)
, R/P , SYNC/HD, and VD
b R
About Your Projector
(5) (6) (7)
(8)
(12) (13) (14)
(15)
(10) S-VIDEO
Connect the S-VIDEO output signal from video
equipment to this jack.
(11) VIDEO
Connect the component or the composite video
output signal from video equipment to these jacks.
(12) AUDIO IN 2
Connect the audio output (stereo) signal from 5 BNC
INPUT jacks (INPUT 2 jacks).
(13) AUDIO IN 3 (L/R)
Connect the audio output (stereo) signal from video
equipment connected to INPUT 3 jacks. For a
monaural audio signal (a single audio jack), connect
it to the L jack.
(14) VARIABLE AUDIO OUT
This jack outputs the audio signal to external audio
equipment.
(15) SERIAL IN
When controlling the projector with RS-232C,
connect the control equipment to this connector with
the serial control cable.
(16) Security slot
This slot is for a Kensington lock used to deter theft
of the projector.
* Kensington is a registered trademark of ACCO
Brands Corporation.
Attention
When a LAN cable is directly connected to the projector,
z
the network connection must be made indoors.
(16)
ENGLISH -
23