Replacing The Lamp Unit - Panasonic PT-EZ570UL Operating Instructions Manual

Replacing the Lamp unit

J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
1 ) Turn off the Power by following the
procedure in "Turning off the projector
( page 40). Unplug the AC power cord.
Æ
Wait at least 1 hour and make sure the
lamp unit and surroundings are cool.
2 ) Use a Phillips screwdriver to loosen
the lamp cover fixing screw and
remove the lamp cover.
Remove the lamp cover by pulling it slowly
z
toward the direction of the arrow.
3 ) Use a Phillips screwdriver to loosen
the three lamp unit fixing screws until
the screws turn freely. Hold the used
lamp unit by its handles, and pull it
gently from the projector.
4 ) Insert the new lamp unit in correct
direction. Tighten the three lamp unit fixing
screws securely with a Phillips screwdriver
5 ) Attach the lamp cover, and tighten the lamp
cover fixing screw securely with a Phillips
screwdriver.
Attach the lamp cover by pushing it slowly
z
opposite the direction of the arrow.
Note
When you replace the new lamp unit (ET-LAE200), the projector
z
resets the total usage time of the lamp unit automatically.
Replacement
Lamp cover
Lamp cover
fixing screw
Lamp unit fixing screws
Handles
ENGLISH -
97