Table of Contents
Advertisement
4. Press the
button to increase the number, or the
button to decrease the number, until the item
you want to adjust is correct.
5. Repeat steps 3 and 4 until the date and time are
correctly adjusted and saved. Press the SELECT
button or BACK button to return to the Settings
menu.
Note:
You need to reset the time and date whenever you replace the
camera's batteries. In this case, you can enter the clock setting
mode directly rather than going through the Settings menu.
See page 20 for instructions.
Setting the alert beep
To turn the camera's alert beep on or off, follow
these steps:
1. With the Settings menu selected, press the SELECT
button. Icons for each setting appear on the screen,
with the clock icon
2. Press the
button to select the beep setting icon
then press the SELECT button to select ON or OFF.
The current selection is highlighted.
Using the LCD Monitor Menus
highlighted in orange.
3. Press the BACK button to save your setting and return
to the Settings menu.
Setting LCD brightness
To adjust the brightness of the LCD screen, follow
the steps below:
1. With the Settings menu selected, press the SELECT
button. Icons for each setting appear on the screen,
with the clock icon
2. Press thebutton until the brightness icon
highlighted in orange, then press the SELECT button
again. The mark on the brightness setting slide bar
turns orange.
3. Slide the mark on the bar by press the
buttons to adjust the screen brightness.
4. Press the SELECT or BACK button to save your setting
and return to the Settings menu.
;
highlighted in orange.
is
and
61
4
Advertisement
Table of Contents
