Setting The Alert Beep; Setting The Lcd Brightness - Epson PhotoPC 600 User Manual

5
Press the button to increase the number, or the
button to decrease the number, until the item you
want to adjust is correct. Then press the BACK button
to save the setting. The item turns orange.
6
Repeat steps 3 to 5 until the date and time are correctly
adjusted and saved. Press the BACK button again to
return to the Camera Settings menu.
NOTE
You need to reset the time and date whenever you replace the
camera's batteries. In this case, you can enter the clock setting
mode directly rather than going through the Camera Settings
menu. See page 1-13 for instructions.

Setting the Alert Beep

To turn the camera's alert beep on or off, follow these steps:
1
With the Settings menu selected, press the SELECT
button. Icons for each setting appear on the screen, as
shown on 8-9.
2
Press the button to select the beep setting icon
8-10 Using Custom and Advanced Features
3
Press the SELECT button to select ON or OFF . The
current selection is highlighted.
4
Press the BACK button to save your setting and return
to the Settings menu.

Setting the LCD Brightness

To adjust the brightness of the screen, follow these steps:
1
With the Settings menu selected, press the SELECT
button. Icons for each setting appear on the screen, as
shown on page 8-9.
2
Press the button until the brightness icon
highlighted in orange.
3
Press the SELECT button again.
4
Press the or
brightness.
5
When you're finished adjusting the screen brightness,
press the BACK button to save your setting and return
to the Settings menu.
.
buttons to adjust the screen
is