Cleaning The Rollers - Fujitsu fi-553PR Operator's Manual

4.3. Cleaning the Rollers

When ink or paper dust is stuck on the Imprinter feed roller
surfaces, documents may not feed smoothly. To prevent
feed problems, clean the roller surfaces regularly.
Recommended cleaning cycle is every 5,000 sheets.
HINT
Actual cleaning cycle may be shorter depending on
usage and documents.
1. Open the Imprinter Cover while the scanner is
turned on.
2. With lint-free cloth, gently wipe off the dirt or dust
to clean the roller surfaces.
Clean lower rubber rollers (total eight) rotating the
rollers by holding down the [Scan] button and [Send
to] button on the operator panel of the Scanner.
Imprinter Cover
When cleaning, be careful not to touch the
ATTENTION
metal wheels located behind the upper rollers
on the Print Cartridge holder cover.
3. Clean the Plastic Rollers.
Clean two black plastic rollers on the inner side of the
Imprinter Cover.
Rotate the rollers with your fingers gently wipe off the
dirt or dust to clean the roller surface with lint-free
cloth.
12 |
Imprinter Cover
4. Confirm that the dirt or dust is removed from the
rollers, then close the Imprinter Cover.