Chapter 37: Review - Creating The Dog Club Design - Brother BES-100E Workbook

Chapter 37: Review – Creating the Dog Club Design
To create the Dog Club design:
1
On the drop-down menu, click
File
2
In the
Files of type
3
In the drop-down list, select the "BES" folder, and then in the list below it, double-click the "Sample"
Look in
folder.
4
In the list, select the "Rundog" file.
Look in
5
Click the button. The "Rundog" file is opened.
Open
6
Click the
Simple Text
the baseline.
7
Click below and to the right of the design to specify the right end of the baseline.
8
Click about 1/2" above the baseline to specify the height of the text. The
log box appears.
9
In the box, type "The Dog Club".
Text
0
In the drop-down list, select "Tallahassee".
Font
A
In the box, type "0.40".
Size
B
In the
Baseline width
C
Select the
Maintain aspect ratio
NOTE: Selecting the
they are adjusted to fit both the baseline width and the text height.
D
On the tab, type "90%" in the
Stitches
NOTE: Adjusting the density properly helps prevent thread breaks while sewing.
E
In the drop-down list in the
Underlay
NOTE: Turning off underlay on small lettering keeps the characters looking neat.
F
Click the button. The text appears below the dog.
OK
NOTE: To display the entire design, click
84
Open
drop-down list, select "BES Files (*.bdf)".
tool ( ), and then click below and to the left of the design to specify the left end of
box, type "4.0".
check box. A check mark will appear.
Maintain aspect ratio
Density adjustment
Underlay stitches
Figure 115
. The dialog box appears.
Open
check box keeps the characters from becoming distorted when
box
group box, select "No".
on the
Fit to Window
tab of the
Text
drop-down menu.
Zoom
dia-
Text Properties