Table of Contents
Advertisement
System Configuration Commands
Set Mode IP config
Command Name
Description
Syntax
Parameters
Example
NOTES
Set IP/Subnet/Gateway Addresses of the system
Command Name
Description
Syntax
Parameters
Example
NOTES
Get IP Address of the system
Command Name
Description
Syntax
Parameters
Example
NOTES
Set System Name
Command Name
Description
Syntax
Parameters
Example
Notes
Get System Name
Command Name
Description
Syntax
Parameters
Example
Notes
(Revised 2011-07-20)
system set modeipconfig
To set the IP address mode of the system
system set modeipconfig <manual|dhcp|bootp>
manual
Uses a static IP address scheme (default mode)
dhcp
Pulls an IP address from a DHCP server on the LAN
bootp
Pulls an IP address from a Bootp server on boot up
N-TRON/Admin#[1]> system set modeipconfig dhcp
Bootp is an older version of DHCP, DHCP is recommended for a
dynamic address scheme.
system set ip
To set the IP address of the system
system set ip <IP-address> <subnet>[ <gateway>]
IP Address
The IP address of the system in dotted decimal notation
Subnet
The subnet of the above specified IP Address
Gateway
The gateway address of the system.
N-TRON/Admin#[1]> system set ip 10.1.1.158 255.0.0.0
N-TRON/Admin#[2]> system set ip 10.1.6.150
255.255.255.0 10.1.6.150
The IP address should be a valid IP address (excluding Class D & Class
E type)
system get ip
To display the IP/Subnet/Gateway addresses of the device
system get ip
None
N-TRON/Admin#[1]> system get ip
system set sysname
To set the system name
system set sysname <Name-of-the-system>
Name-of-the-system
The system name to be used
N-TRON/Admin#[1]> system set sysname N-Tron
N-TRON/Admin#[2]> system set sysname "N-Tron Switch"
Please ensure to use " " for supplying arguments with spaces
system get sysname
To display the name of the system
system get sysname
None
N-TRON/Admin#[1]> system get sysname
System Name
: N-TRON Switch
page 98 of 145
Advertisement
Table of Contents
