Show IGMP router
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set IGMP query mode
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set IGMP router port
Command Name
Description
Syntax
Parameters
Examples
NOTES
Set IGMP router mode
Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-20)
igmp show router
The igmp show router command is used to display the auto-detected routers
at present.
igmp show router
None
N-TRON/Admin#[1]> igmp show router
RouterIp
PortNo
------------------------
192.168.1.150
The router display is used to check that the router ip & port number was
received correctly.
igmp set qmode
Set the query mode of the switch to either on, off, or automatic.
igmp set qmode <off | on | auto>
off | on | auto
There are three different query modes; off, on, and auto.
N-TRON/Admin#[1]> igmp set qmode auto
Default: Auto
igmp set rtrport
Enable or disable a router port based on a port-range.
igmp set rtrport <port-range> <enable | disable>
port-range
enter a range of port numbers.
enable | disable
enable or disable the router port.
N-TRON/Admin#[1]> igmp set rtrport 1-4 enable
igmp set rtrmode
The igmp show router command is used to display the router group present
in the group list
igmp set rtrmode <none | manual | auto>
none | manual | auto
There are three different router modes available; none, manual, and
auto.
N-TRON/Admin#[1]> igmp set rtrmode auto
Default: Auto
5
page 127 of 145