Table of Contents
Advertisement
Get STP Status
Command Name
Description
Syntax
Parameters
Examples
NOTES
Get Back Pressure
Command Name
Description
Syntax
Parameters
Examples
NOTES
Get PVID
Command Name
Description
Syntax
Parameters
Examples
NOTES
Clear Counters
Command Name
Description
Syntax
Parameters
Examples
NOTES
Clear Intruder Log
Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-20)
port get STP Status
Displays the Spanning Tree Protocol Status on a given port.
port get stpstatus <port-no>
port-no
port number (1 ~ 26)
N-TRON/Admin#[1]> port get stpstatus 6
Stp state of [6] port is : [Forward]
STP states include: Listening, Learning, Blocking, & Forwarding
port get backpressure
Displays the backpressure information on a given port number (enabled or
disabled).
port get backpressure <port-no>
port-no
port number (1 ~ 24)
N-TRON/Admin#[1]> port get backpressure 6
Back Pressure is DISABLED
Check whether port-no is in the valid range. (1 ~ 24)
port get pvid
Displays a given port‟s VLAN-ID.
port get pvid <port-no>
port-no
port number (1 ~ 26)
N-TRON/Admin#[1]> port get pvid 6
PVID of port 6 is 4.
Check whether port-no is in the valid range. (1 ~ 26)
port clear counters
Clears all the numbers in the counters for a given port. These are counters
for RX bytes and TX bytes and so on.
port clear counters <port-no>
port-no
port number (1 ~ 24)
N-TRON/Admin#[1]> port clear counters 6
Counters of Port[6] are : [cleared]
This will clear all data in the port specific counters. This data cannot be
recovered after this step.
port clear intruderlog
This command will clear all intruders out of the intruder log.
port clear intruderlog
None
N-TRON/Admin#[1]> port clear intruderlog
This will clear all data from the intruder log. This data can not be
recovered after this step.
page 114 of 145
Advertisement
Table of Contents
