Midi Transmit Settings - Yamaha Tyros4 Reference Manual

MIDI Transmit Settings

The explanations here apply to the TRANSMIT Page in step 4 on
MIDI data and over which MIDI channel the data will be sent.
1
1
Use the [A]/[B] buttons or [1 ]/[2 ] buttons to select the
part for changing transmit settings.
With the exception of the two parts below, the configuration of the parts is the
same as those already explained elsewhere in the Owner's Manual.
UPPER
A keyboard part played on the right side of the keyboard from the Split Point for
the Voices (RIGHT 1, 2, and 3).
LOWER
A keyboard part played on the left side of the keyboard from the Split Point for the
Voices. This is not affected by the on/off status of the [ACMP] button.
2
Use the [3 ] buttons to select a channel via which the
selected part will be transmitted.
3
Use the [4 ]–[8 ] button to determine the types of data
to be sent.
The following MIDI messages can be set on the TRANSMIT/RECEIVE display.
NOTE (Note events) .........................................
CC (Control Change).......................................
PC (Program Change) .....................................
PB (Pitch Bend)................................................
AT (Aftertouch)................................................
page
1 2 3
page 74
page 74
page 74
page 74
page 74
124. This determines which parts will be sent as
The dots corresponding to
each channel (1–16) flash
briefly whenever any data is
transmitted on the channel(s).
NOTE
If the same transmit channel is assigned
to several different parts, the transmitted
MIDI messages are merged to a single
channel—resulting in unexpected
sounds and possible glitches in the
connected MIDI device.
NOTE
Protected Songs cannot be transmitted
even if the proper Song channels 1–16
are set to be transmitted.
Tyros4 Reference Manual
11
127