Memory Locations And Replacement Procedures; Mode Switch Location On 2G4082-25 - Enterasys Matrix 2G4082-25 Hardware Installation Manual

Memory Locations and Replacement Procedures

• Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Figure B-1
1 Mode switch bank
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory
Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and
replace these memory modules. If you have questions concerning the replacement of either
memory module, refer to "Getting Help" on page xiii for details on how to contact Enterasys
Networks.
B-2 Mode Switch Bank Settings and Optional Installations
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.

Mode Switch Location on 2G4082-25

À