Enterasys Matrix 2G4082-25 Hardware Installation Manual page 43

Table 4-1 LANVIEW LEDs (continued)
LED Color
CPU None
Amber
Green
Red
Green
and
Amber
Amber
and off
RX None
(Receive)
Green
Amber
Red
TX None
(Transmit)
Green
Red
State
Power off.
Blinking. Module in process of
booting.
Solid. Testing.
Blinking. Image starts running.
Solid. Functional.
Solid. Processor in reset.
Blinking. Indicates that the
module is in the process of
shutting down.
Alternating (67% on, 33% off).
Indicates that a shutdown
process has completed. This
indication will remain for 60
seconds before automatically
restarting.
No link. No activity. Port
enabled or disabled.
Solid. Link present, port
enabled, no traffic is being
received by the interface.
Flashing. Link present, port
enabled, traffic is being received
by the interface.
Blinking. Indicates collisions.
This indication is only supported
on 10/100 ports.
Port enabled, but no activity.
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data rate.
Flashing. Fault or Error
(collision).
Recommended Action
Ensure chassis has adequate power.
None.
If the LED remains amber for several
minutes, contact Enterasys Networks for
technical support.
None.
None.
None.
None. This state is activated when the
OFFLINE/RESET switch is pressed for less
than 1 second to a start the process of an
orderly shutdown.
While in this state, do not remove any
DFE-Platinum module.
While in this state, you have 60 seconds to
safely remove the DFE-Platinum module
from the chassis.
None.
None.
None.
Contact Enterasys Networks for technical
support.
If it is known that the port should be active
and is not, contact Enterasys Networks for
technical support.
None.
None, unless there is a high rate of activity.
In this case, check for network configuration
problems or a defective device.
Matrix DFE-Platinum Series Installation Guide 4-3
Using LANVIEW