Brother MFC-665CW User Manual page 154

!! _ ! !!!]! !_ !!!! !!, !! i_ :!!!! !!!!!!! i!!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!! !!!!! ....
Out of Memory
The machine's memory is full. Fax sending or copy operation in
progress
Do one of the following:
[] Press Stop/Exit and wait until the other
operations in progress finish and then
try again.
[] Clear the data in the memory. To gain
extra memory, you can turn off
Advanced Fax Operation. (See Turning
off Advaneed Fax Operations on
page 81 .)
[] Print the faxes that are in the memory.
(See Printing a fax from the memory on
page 51 .)
Printing operation in progress
Reduce print resolution. (For details, see
Printing for Windows ® or Printing and
Faxing for Macintosh ® in the Software
User's Guide on the CD-ROM.)
Open the Jam Clear Cover (at the back of
the machine) and remove the jammed
paper. (See Printer jam or paper jam on
page 141.)
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, do one of the
following:
[] (MFC-440CN only)
See Transferring your faxes or Fax
Journal reporton page 139 before
disconnecting the machine so you will
not lose any important messages.
Then, disconnect the machine from the
power for several minutes and then
reconnect it.
[] (MFC-665CW only)
Disconnect the machine from the
power for several minutes, then
reconnect it. (The machine can be
turned off for approximately 24 hours
without losing faxes stored in the
memory. See Transferring your faxes
or Fax Journal report on page 139.)
Load the correct size of paper (Letter,
Legal or A4), and then press Black Start
or Color Start.
Unplug the device from the PictBridge port,
then press On/Off to turn the machine off
and then on again.
Paper Jam
Unable to Change
XX
Unable to Clean XX
Unable to Init. XX
Unable to Print XX
Paper is jammed in the machine.
The machine has a mechanical
problem.
--OR--
A foreign objects such as a clip or
ripped paper is in the machine.
Unable to Scan XX
Wrong Paper Size
Paper is not the correct size.
Wrong USB device A non-PictBridge compatible or
broken device has been
connected to the PictBridge port.
_38