Cr_System Command - Sanyo PLC-XD2200 - XGA Able Multimedia Projector Manual

PLC-XD2200/2600 Expand Serial Command Functional Specifications
9.7.6

CR_SYSTEM Command

Command "CR_SYSTEM"[CR]
Details Get selected System
Acceptable
Response %1
Unacceptable
"000_%1"[CR]
"VGA1" -------------- VGA1 is selected
"VGA2" -------------- VGA2 is selected
ÿ
"XGA1"-------------- XGA1 is selected
ÿ
"WXGA3" --------- WXGA3 is selected
"1080i" ------------ 1080i is selected
"1035i" ------------ 1035i is selected
Input is
"720p" ------------- 720p is selected
PC Analog "575p" ------------- 575p is selected
"480p" ------------- 480p is selected
"575i" -------------- 575i is selected
"480i" -------------- 480i is selected
"MODE1" ------- Mode1 is selected
ÿ
"MODE10" -------------- Mode10 is selected
When there is no signal, projector returns error code"101"
[CR]
"AUTO" ----------- Auto is selected
"1080i" ------------1080i is selected
"1035i" ------------ 1035i is selected
"720p" ------------- 720p is selected
Input is
"575p" ------------- 575p is selected
Y,Pb/Cb,Pr
"480p" ------------- 480p is selected
/Cr
"575i" -------------- 575i is selected
"480i" -------------- 480i is selected
Projector returns selected System status regardless of the
signal input.
"AUTO" --------------- Auto is selected
"NTSC" --------------- NTSC is selected
"NTSC443" ---------- NTSC4.43 is selected
"PAL" ------------------ PAL is selected
Input is
"SECAM" ------------- SECAM is selected
Video,S-Vi
"PALÿ M" ------------- PAL-M is selected
deo
"PALÿ N" ------------- AL-N is selected
Projector returns selected System status regardless of the
signal input.
""Error Code"[CR]
54 / 71