Cr_Terminal Command; Cr_Standbymode Command; Cr_P-Mane Command; Cr_P-Manetime Command - Sanyo PLC-XD2200 - XGA Able Multimedia Projector Manual

PLC-XD2200/2600 Expand Serial Command Functional Specifications

9.11.10 CR_TERMINAL Command

Command "CR_TERMINAL" [CR]
Details Get setting status of Terminal
Acceptable
Response %a
Unacceptable
9.11.11

CR_STANDBYMODE Command

Command "CR_STANDBYMODE" [CR]
Details Get Standby Mode setting status
Acceptable
Response %a
Unacceptable

9.11.12 CR_P-MANE Command

Command "CR_P-MANE"[CR]
Details Get Power management setting status
Acceptable
Response %a
Unacceptable

9.11.13 CR_P-MANETIME Command

Command "CR_P-MANETIME"[CR]
Details Get time to start Power Management
Acceptable
Response %a
Unacceptable

9.11.14 CR_ON-STA Command

Command "CR_ON-STA"[CR]
Details Get Direct On setting status
Acceptable
Response %a
Unacceptable
"000_%a"[CR]
"COMPUTER"-------------Computer Input mode
"MONITOR"----------------Monitor Out mode
"?"[CR]
"000_%a"[CR]
"ECO" -------------- Eco Mode
"NORMAL" -------- Normal Mode
"?"[CR]
"000_%a"[CR]
"OFF" -------------------------- Power Management is OFF
"READY" ---------------------- Power Management is Ready
"SHUTDOWN" ---- Power Management is set to Shut Down mode
"Error Code" [CR]
"000_%a"[CR]
"001"~"030" -----------------------1 minute to 30 minutes
"Error Code" [CR]
"000_%a"[CR]
"ON" -------------------------- Direct On Start is ON
"OFF" ------------------------- Direct On Start is OFF
"Error Code" [CR]
63 / 71