Other Command; Cf_Keyenu Command; Cf_Menu Command; Cf_Power Command - Sanyo PLC-XD2200 - XGA Able Multimedia Projector Manual

PLC-XD2200/2600 Expand Serial Command Functional Specifications

8.11 Other Command

8.11.1 CF_KEYENU Command

Command "CF_KEYENU_%1"[CR]
"RIGHT" ------------------------- Shift Pointer on OSD Menu to right
"LEFT" --------------------------- Shift Pointer on OSD Menu to left
"UP" ------------------------------ Shift Pointer on OSD Menu to right
%1
"DN" ------------------------------ Shift Pointer on OSD Menu to right
"SELECT" ----------------------- Behave the same as Select key
"AUTOPC" ---------------------- Execute Auto PC adj
This command behave the same as corresponding keys of Remote Control /
Projector
Details
Auto PC adj. keeps operating even though projector receives this command again
while Auto PC adj. is in process.
Acceptable
Response
Unacceptable

8.11.2 CF_MENU Command

Command "CF_MENU_%1"[CR]
"ON" ----------------------------- Display OSD Menu
%1
"OFF" --------------------------- Cancel OSD menu
Display / Cancel On Screen Display Menu
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.11.3 CF_POWER Command

Command "CF_POWER_%1"[CR]
"ON" ------------Power ON projector
"OFF" ---------- Power OFF Projector
Note1) Countdown can be terminated by sending this command.
%1 Note2) Projector returns error code due to unable of command execution depends
on its condition.
Note3) Although projector returns "OK", operation may not be proceeding properly.
(e.g.
temperature.) Use Status read command to get projector states.
Details Power ON / OFF projector.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
After returning "000" for Power ON command, projector gets abnormal
"000"[CR]
"Error Code"[CR]
43 / 71