Cf_Ptimemode Command; Cf_Ptimer Command; Cf_Ptime Command; Cf_Rcode Command - Sanyo PLC-XD2200 - XGA Able Multimedia Projector Manual

PLC-XD2200/2600 Expand Serial Command Functional Specifications

8.10.17 CF_PTIMEMODE Command

Command "CF_PTIMEMODE_%1"[CR]
"COUNTUP" ---------------- Select Count up
%1
"COUNTDN" ---------------- Select Countdown
Set operation mode of P-timer.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.18 CF_PTIMER Command

Command "CF_PTOMER_%1"[CR]
"START" ----------------------- Execute P-timer
"STOP" ------------------------ Pause P-timer
%1 "RESTART" ------------------ Restart P-timer
"RST" -------------------------- Reset P-timer
"EXIT" -------------------------- Terminate P-timer function
Control P-timer.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.19 CF_PTIME Command

Command "CF_PTIME_%1"[CR]
%1 "001" ~ "180" -----------Directly specify the timer by minutes.
Set Countdown timer for P-timer function.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.20 CF_RCODE Command

Command "CF_RCODE_%1"[CR]
"001" --------------------------- Select Code1
"002" --------------------------- Select Code2
"UP" --------------- Switch Code setting of Remote Control forward
%1
"DN" --------------- Switch Code setting of Remote Control backward
Select Code of Remote Control
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
(Code1 → Code2 → Code1 ...)
(Code2 → Code1 → Code2...)
"000"[CR]
"Error Code"[CR]
39 / 71