Cf_Imageadj Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications
"CUSTOM4" ------------- Image4 ÿ the value adjusted and stored by userÿ
Select Image Mode (Available only in the normal Power ON status)
Parameter "CUSTOM1" to "CUSTOM4" corresponds to "Image1" to "Image4"
Details displayed in projector OSD menu on selecting Image.
The value set by this command is stored in EEPROM so that the setting can
remain effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.4.12 CF_IMAGEADJ Command

Command "CF_IMAGEADJ_%1"[CR]
"RST"------ Reset adjusted value for the Image
"STR1"---- Store current adjusted value to Image 1
%1 "STR2"---- Store current adjusted value to Image 2
"STR3"---- Store current adjusted value to Image 3
"STR4"---- Store current adjusted value to Image 4
Reset or Store adjusted value for Image.
(Available only in the normal Power ON status)
"STR1"-"STR4" corresponds to "Image1"-"Image4" displayed in projector OSD
Details
menu on selecting "Store" for adjusted value of Image. The setting value set in
"Image1" to "Image4" is stored and can be retrieved when turning on the projector
again after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
20/75