Cr_Rcode Command; Cr_Rcsensor Command; Cr_Rtype Command; Cr_Disp Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications

9.11.9 CR_RCODE Command

Command "CR_RCODE" [CR]
Details Get selected Remote Control Code
Acceptable
Response %1
Unacceptable

9.11.10 CR_RCSENSOR Command

Command "CR_RCSENSOR"[CR]
Details Get selected location of infrared remote receiver of remote control
Acceptable
Response %1
Unacceptable

9.11.11 CR_RTYPE Command

Command "CR_RTYPE" [CR]
Details Get status of supported Remote Control (IR/RF).
Acceptable
Response %1
Unacceptable

9.11.12 CR_DISP Command

Command "CR_DISP" [CR]
Details Get setting status of Display
Acceptable
Response %1
Unacceptable
"000_%1" [CR]
"001" --------------------------- Code 1 is selected
"002" --------------------------- Code 2 is selected
"003" --------------------------- Code 3 is selected
"004" --------------------------- Code 4 is selected
"005" --------------------------- Code 5 is selected
"006" --------------------------- Code 6 is selected
"007" --------------------------- Code 7 is selected
"008" --------------------------- Code 8 is selected
"Error Code" [CR]
"000_%1" [CR]
"ALL" ------------------ Front and back and top parts are valid
"FRONTTOP" ------- Both front and top parts are valid
"BACKTOP" --------- Both back and top parts are valid
"FRONTBACK" ----- Both front and back parts are valid
"FRONT" ------------- Only front part is valid
"TOP" ----------------- Only top part is valid
"BACK" --------------- Only back part is valid
"Error Code" [CR]
"000_%1" [CR]
"IR" -------- IR
"RF" ------- RF (cannot be returned as this model supports only
IR remote control)
"Error Code" [CR]
"000_%1" [CR]
"ON" --------------------------- Display is ON
"CNTDWNOFF" ------------ Count down is OFF
"OFF" ------------------------- Display is OFF
"Error Code" [CR]
67/75