Smtp Setup Menu - Lexmark CS410 Series User Manual

Understanding the printer menus
Use
NPA Mode
On
Off
Auto
USB Buffer
Disabled
Auto
3K to [maximum size allowed]
Mac Binary PS
On
Off
Auto
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
ENA Gateway
yyy.yyy.yyy.yyy

SMTP Setup menu

Use
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
To
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
•
Auto is the factory default setting. Auto sets the printer to examine data,
determine the format, and then process it appropriately.
•
The printer automatically restarts when changing the setting from the printer
control panel. The menu selection is then updated.
Set the size of the USB input buffer.
Notes:
•
Auto is the factory default setting.
• Disabled turns off job buffering. Any jobs already buffered in the printer hard
disk are printed before normal processing resumes.
•
The USB buffer size value can be changed in 1KB increments.
•
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is enabled or
disabled.
• To increase the maximum size range for the USB Buffer, disable or reduce the
size of the parallel, serial, and network buffers.
•
The printer automatically restarts when the setting is changed from the printer
control panel. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
•
On processes raw binary PostScript print jobs.
•
Off filters print jobs using the standard protocol.
Set the network address, netmask, and gateway information for an external print
server.
Note: This menu is available only when the printer is attached to an external print
server through the USB port.
To
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
82