Connecting The Printer To A Wireless Network Using Wi-Fi Protected Setup (Wps) - Lexmark CS410 Series User Manual

Additional printer setup
•
802.1X user name and password
• Certificates
–
No security
If your wireless network does not use any type of security, then you will not have any security information.
Note: Using an unsecured wireless network is not recommended.
Notes:
– If you do not know the SSID of the network that your computer is connected to, then launch the wireless utility
of the computer network adapter, and then look for the network name. If you cannot find the SSID or the
security information for your network, then see the documentation that came with the access point, or contact
your system support person.
–
To find the WPA/WPA2 preshared key/passphrase for the wireless network, see the documentation that came
with the access point, see the Web page associated with the access point, or consult your system support
person.

Connecting the printer to a wireless network using Wi-Fi Protected Setup (WPS)

Before you begin, make sure that:
•
The access point (wireless router) is WPS certified.
•
A wireless network adapter is installed in the printer and is working properly. For more information, see the
instruction sheet that came with the wireless network adapter.
Using the Push Button Configuration (PBC) method
1
From the printer control panel, navigate to:
> Settings >
Wi‑Fi Protected Setup >
2
Follow the instructions on the printer display.
Using the Personal Identification Number (PIN) method
1
From the printer control panel, navigate to:
> Settings >
PIN Method >
2
Copy the eight‑digit WPS PIN.
3
Open a Web browser, and then type the IP address of your access point in the address bar.
Notes:
•
The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
4
Access the WPS settings.
5
Enter the eight‑digit PIN, and then save the setting.
>Network/Ports >
> Start Push Button Method >
>Network/Ports > > Network [x] > Wireless >
> Network [x] > > Network [x] Setup > > Wireless >
> Wi‑Fi Protected Setup >
32
>
> Start