Operating Your Ceiling Fan - Emerson KF240PRZ00 Owner's Manual

BP7308 LORRAINE KF240
9. Place the second wall control into the
wall box. Screw in place and install
decorator style faceplate (included).
Leave switch in "OFF" mode until fan
installation is completed.
10. Refer to page 5 and complete the
ceiling fan installation .
STANDARD WIRING FOR EXISTING
3-WAY CONTROL
EXISTING
WALL CONTROL
HOT BLK
TRAVELER WIRES
HOT BLK
HI
LIGHT
MED
LOW
FAN OFF
EMERSON ®
OFF ON
FAN/LIGHT
WALL CONTROL
TRAVELER WIRES
Figure 22
Operating Your
Ceiling Fan
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing of the remote
control.
Your Fan/Light Wall Control (Figure 23)
has full control of your fan and light.
However, airflow direction is controlled by
a slide switch on the light fitter.
1. Restore electrical power to the outlet
box by turning the electricity on at the
service panel.
NOTE: Make sure that the ON/OFF slide
switch on the Fan/Light Wall Control is
in the ON position.
2. To set the desired fan speed, press the
HI, MED, or LOW buttons to operate
your fan on high, medium, or low speed
(Figure 23).
2/15/06 3:21 PM Page 15
3. To turn your fan off, press the OFF
button.
4. To set the level of light brightness,
press and hold the LIGHT button. The
light
increase then decrease while the
button is held down. When the light is
at the desired brightness, release the
button.
5. To turn the light on and off, press and
release the LIGHT button. The light will
turn on at the light level previously set
(see step 4).
6. If airflow is desired in the opposite
direction, turn the fan off and wait for
the blades to stop turning. Remove the
LOAD
lower glass (Figure 17), then slide the
reversing switch (located on the light
fitter) to the opposite position and turn
BLK
HI
LIGHT
the fan on again. The blades will turn in
MED
LOW
FAN OFF
the opposite direction and reverse the
EMERSON ®
OFF ON
airflow.
LOAD
Figure 23
15
brightness will continue
HI
LIGHT
MED
LOW
FAN OFF
®
EMERSON
OFF ON
to