How To Wire Your Ceiling Fan - Emerson KF240PRZ00 Owner's Manual

BP7308 LORRAINE KF240
How to Wire
Your Ceiling Fan
If you feel that you do not have enough
electrical wiring
experience, have your fan installed by a
licensed electrician.
WARNING
!
Turning off wall switch is not
sufficient. To avoid
electrical shock, be sure electricity is
turned off at the main fuse box
before wiring. All wiring must be in
accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
CAUTION: To reduce the risk of
electrical shock,
electrical supply
installing the fan, light kit or receiver.
1. Position the supply wires to the left side
of the outlet box (Figure 14); position
the fan wires to the right side. Partially
insert the remote control receiver (flat
side up) until one end rests on the
hanger ball as shown in Figure 14.
NOTE: Make all wiring connections
using wire connectors (supplied). Make
sure that all connections are tight,
SUPPLY WHITE WIRE
(NEUTRAL)
SUPPLY BLACK
WIRE (HOT)
GROUND WIRE
GREEN GROUND
WIRE FROM
HANGER BALL
ANTENNA
GREEN GROUND
WIRE FROM
HANGER BRACKET
1-1/4" THREADED
STUD (2)
Figure 14
2/15/06 3:21 PM Page 11
including ground, and that no bare wire
is visible at the wire connectors, except
for the ground wire.
2. Refer to Figures 14 and 15 and connect
the receiver wires to the supply wires
knowledge or
and the fan motor wires as follows:
a. Securely connect the green grounding
wires from the hanger ball and the
hanger bracket to the supply grounding
conductor (this may be a bare wire or a
wire with green insulation).
possible
b. Securely connect the supply white
(neutral) wire to the receiver white
(AC IN N) wire.
c. Securely connect the supply black wire
(hot) wire to the receiver black (AC IN
L) wire.
d. Securely connect the fan motor white
wire to the receiver white (TO MOTOR
N) wire.
e. Securely connect the fan motor black
disconnect the
wire to the receiver red (TO MOTOR L)
circuit before
wire.
f. Securely connect the fan motor blue
wire to the receiver blue (FOR
LIGHT) wire.
Check to see that all connections are
tight, including ground, and that no
bare wire is visible at the wire
connectors, except for the ground
wire. Do not operate fan until blades
are in place. Noise and fan damage
could result.
RECEIVER WHITE
WIRE
FAN
BLACK
WIRE
FAN BLUE WIRE
FAN WHITE WIRE
11
WARNING
!
RECEIVER
BLACK WIRE
RECEIVER RED WIRE
RECEIVER BLUE
WIRE
RECEIVER WHITE WIRE