Your Ceiling Fan How To Hang - Emerson KF240PRZ00 Owner's Manual

BP7308 LORRAINE KF240
! WARNING
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly
installed could result in the fan falling.
16. Place the ceiling cover over the
downrod. Then reinstall the hanger
ball (Figure 10) on the downrod as
follows. Route the three 80" motor
leads through the hanger ball and
slide the hanger ball over the
downrod. Position the pin through the
two holes in the downrod and align
the hanger ball so the pin is captured
in the groove in the top of the hanger
ball. Pull the hanger ball up tight
against the pin and securely tighten
the setscrew in the hanger ball. A
loose setscrew could create fan
wobble.
PIN
HANGER
BALL
DOWNROD
Figure 10
17. The fan comes with blue, black and
white leads that are 80" long. Before
installing the fan,
approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut
off excess leads and strip back
insulation 1/2" from end of leads.
18. You have now completed the initial
assembly of your new ceiling fan. You
can now proceed with hanging and
wiring your fan.
2/15/06 3:21 PM Page 9
The fan must be hung with at least 7'
of clearance from floor to blades
(Figure 11).
AT LEAST
7'
Figure 11
The outlet box and joist must be
securely mounted and capable of
SETSCREW
supporting at least 50 lbs. Use only a
U.L. outlet box listed as "Acceptable
for Fan Support".
CEILING
To reduce the risk of fire, electric
COVER
shock, or personal injury, mount fan
to outlet box marked "Acceptable for
Fan Support", and use screws
supplied with outlet box. Most outlet
boxes commonly used for support of
measure up
light fixtures are not acceptable for
fan support and may need to be
replaced.
electrician if in doubt.
1. Securely attach the hanger bracket to
the outlet box using the two screws
supplied with the outlet box (Figure 12).
9
How to Hang
Your Ceiling Fan
WARNING
!
CEILING
FLOOR
WARNING
!
WARNING
!
Consult a qualified