Page 1
BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 1 READ AND SAVE THESE INSTRUCTIONS Emerson Fans Designed by LORRAINE Ceiling Fan Owner's Manual Model Number KF240PRZ00 Parisian Bronze with Dark Cherry/Walnut Blades 27.0 Net Weight: Lbs. Part No. F40BP73080000 Form No. BP7308...
9 foot ceiling. The 8” downrod (supplied) must be used for an 8 foot ceiling. 5. The fan must be mounted with the fan blades at least 7 feet from the floor to prevent accidental contact with the fan blades.
Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage. 1. Open styrofoam unit containing fan.
Page 4
Place the fan assembly into the lower foam pad with the bottom of the motor facing up. The lower foam pad serves as a holder for the fan during the first stages of assembly. LIGHT FAN OFF EMERSON...
3:21 PM Page 5 Ceiling Fan Procedures General Your Emerson ceiling fan comes supplied with a Fan/Light Wall Control which consists of a wall control (transmitter) and Wall a remote control receiver mounted under the ceiling cover. This system allows you...
Page 6
BLADE FLANGE 2. Remove and discard the four shipping retainers securing the motor hub in the motor housing. NOTE: Take care not to scratch the fan housing when installing the blade assemblies. 3. Position the blade flange on the motor...
Page 7
(Figure 6). Carefully place the partially assembl- ed ceiling fan on the styrofoam halves, with the light fitter assembly positioned in the gap and the fan assembly resting on the fan blade assemblies. PARTIALLY ASSEMBLED FAN...
Page 8
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 8) could result in the fan falling. DOWNROD HAIRPIN CLIP MOTOR...
3:21 PM Page 9 How to Hang Your Ceiling Fan WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 11). CEILING AT LEAST FLOOR Figure 11...
Page 10
OUTLET BOX HANGER BRACKET Figure 12 2. Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 13). Be sure the groove in the ball is lined up with the tab on the hanger bracket (Figure 12).
1. Position the supply wires to the left side of the outlet box (Figure 14); position the fan wires to the right side. Partially insert the remote control receiver (flat side up) until one end rests on the hanger ball as shown in Figure 14.
Page 12
1/8-27 nut (washers and nut are supplied). 8. Place the decorative cap over the threaded nipple and then screw on the finial nut (Figure 17). 9. Your ceiling fan is now installed and wired to be controlled by your fan/light wall control.
Page 13
2. In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate. 3:21 PM Page 13...
Page 14
FAN/LIGHT WALL CONTROL Figure 20 3-WAY INSTALLATION (On fan controlled by two different wall controls) (See Figures 21 and 22.) 1. Disconnect power at circuit breaker or remove fuse. 2. At all wall box locations remove faceplates and screws from existing controls.
NOTE: Make sure that the ON/OFF slide switch on the Fan/Light Wall Control is in the ON position. 2. To set the desired fan speed, press the HI, MED, or LOW buttons to operate your fan on high, medium, or low speed (Figure 23).
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co.
BP7308 LORRAINE KF240 2/15/06 WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE 1. Fan will not 1. Fuse or circuit breaker start. blown. 2. Loose power line connections to the fan.
• PART NUMBER • NAME OF ITEM • PART DESCRIPTION • MODEL NUMBER The model number of your Fan will be found on a label attached to the top housing. For repair parts, phone 1-800-654-3545. 3:21 PM Page 18 LIGHT...
If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson Electric Co. will refund the actual purchase price of your fan.