Table of Contents
Advertisement
BP7308 LORRAINE KF240
Electrical Requirements
IMPORTANT: Your ceiling fan will not
function
properly,
damaged, if used with any wall dimmer
switch or control other than the
Emerson
Electric
Control supplied with the fan, or an
optional
Emerson
Remote Control.
Your new ceiling fan will require a
grounded electrical supply line of 120 volts
AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored
and capable of withstanding a load of at
least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked "Acceptable for Fan Support",
and use screws supplied with outlet box.
Most outlet boxes commonly used for
support
of
light
fixtures
acceptable for fan support and may need
to be replaced. Consult a qualified
electrician if in doubt.
If your fan is to replace an existing ceiling
light fixture, turn electricity off at the main
fuse or circuit breaker box at this time and
remove the existing light fixture.
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
2/15/06
3:21 PM
Page 5
Ceiling Fan Procedures
and
may
be
Your Emerson ceiling fan comes supplied
with a Fan/Light Wall Control which
consists of a wall control (transmitter) and
Fan/Light
Wall
a remote control receiver mounted under
the ceiling cover. This system allows you
Electric
SR100
to regulate your ceiling fan speed and light
intensity.
NOTE: An optional Emerson Electric
SR100 Remote Control may also be
used to control your ceiling fan.
How to Assemble Your
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
are
not
fan must be properly grounded as a
precaution against possible electrical
shock.
IMPORTANT: Before assembling your
ceiling fan, refer to sections "Setting
Operating Frequency of Wall Control
and Receiver" and "Installation of Wall
Control", page 13. These sections
instruct you how to: a) Set the
operating frequency of the fan/light
wall control and the remote control
receiver; and b) Install the fan/light wall
control in the wall box. You will then be
ready to proceed with the assembly
and installation of your ceiling fan, as
follows:
1. Mount the fan blades to the blade
flanges using three 10-24 x 8mm truss
head screws and three flat washers
(screws
(Figure 1).
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blade flanges, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
5
General
Ceiling Fan
WARNING
!
and
washers
supplied)
WARNING
!
Advertisement
Table of Contents
