Hitachi L300P Series Instruction Manual page 229

Reactance
The impedance of inductors and capacitors has two components. The resistive part is constant,
while the reactive part changes with applied frequency. These devices have a complex imped-
ance (complex number), where the resistance is the real part and the reactance is the imaginary
part.
Rectifier
An electronic device made of one or more diodes that converts AC power into DC power.
Rectifiers are usually used in combination with capacitors to filter (smooth) the rectified
waveform to closely approximate a pure DC voltage source.
Regenerative
A particular method of generating reverse torque to a motor, an inverter will switch internally to
allow the motor to become a generator and will either store the energy internally, deliver the
Braking
braking energy back to the main power input, or dissipate it with a resistor.
Regulation
The quality of control applied to maintain a parameter of interest at a desired value. Usually
expressed as a percent (+/-) from the nominal, motor regulation usually refers to its shaft speed.
Reverse Torque
The torque applied in the direction opposite to motor shaft rotation. As such, reverse torque is a
decelerating force on the motor and its external load.
Rotor
The windings of a motor that rotate, being physically coupled to the motor shaft. See also
stator.
Saturation
For a transistor semiconductor device, it is in saturation when an increase in input current no
Voltage longer results in an increase in the output current. The saturation voltage is the voltage drop
across the device. The ideal saturation voltage is zero.
Sensorless
A technique used in variable-frequency drives (such as the SJ100 and SJ300 series) to rotate the
Vector Control force vector in the motor without the use of a shaft position sensor (angular). Benefits include
an increase in torque at the lowest speed and the cost savings from the lack of a shaft position
sensor.
Setpoint (SP)
The setpoint is the desired value of a process variable of interest. See also Process Variable
(PV) and PID Loop.
Single-phase
An AC power source consisting of Hot and Neutral wires. An Earth Ground connection usually
accompanies them. In theory, the voltage potential on Neutral stays at or near Earth Ground,
Power
while Hot varies sinusoidally above and below Neutral. This power source is named Single
Phase to differentiate it from three-phase power sources. Some Hitachi inverters can accept
single phase input power, but they all output three-phase power to the motor. See also three-
phase.
Slip
The difference between the theoretical (synchronous) speed of a motor at no load (determined
by its inverter output waveforms) and the actual speed. Some slip is essential in order to
develop torque to the load, but too much will cause excessive heat in the motor windings and/or
cause the motor to stall.
Squirrel Cage
A "nick-name" for the appearance of the rotor frame assembly for an AC induction motor.
Stator
The windings in a motor that are stationary and coupled to the power input of the motor. See
also rotor.
Start Frequency
The output frequency that the inverter first produces as the frequency command setting
increases from zero. The start frequency is programmable, and is important to set properly for
the load, etc.
Tachometer
1. A signal generator usually attached to the motor shaft for the purpose of providing feedback
to the speed controlling device of the motor. 2. A speed-monitoring test meter that may
optically sense shaft rotation speed and display it on a readout.
A–5
L300P Inverter