Parallel Interface - Ricoh PRO 1106EX Operating Instructions Manual

System Settings

Parallel Interface

This section describes various items of [Parallel Interface] under [Interface Settings].
[Parallel Interface] is displayed when this machine is installed with the IEEE 1284
interface board (optional).
❖ Parallel Timing
2
Sets the timing for the control signal of the parallel interface.
• ACK outside
• ACK inside
• STB down
❖ Parallel Communication Speed
Sets the communication speed for the parallel interface.
• High Speed
• Standard
❖ Selection Signal Status
Sets the level for the select signal of the parallel interface.
• High
• Low
❖ Input Prime
Sets whether to validate or invalidate the input prime signal upon receipt.
• Active
• Inactive
❖ Bidirectional Communication
Sets the printer's response mode to a status acquisition request when using a
parallel interface.
• On
• Off
When set to [Off], bidirectional communication function will be disabled. Al-
so, printer driver will not be installed under Windows Auto Detect function.
❖ Signal Control
Sets procedure to error during printing.
• Job Acceptance Priority
• Printer Priority
56