Interface Settings/Parallel Interface - Ricoh Aficio 1035 Operating Instructions Manual

Interface Settings/Parallel Interface

Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circum-
stances, you will not need to change this setting.
Note
Default: ACK outside
Parallel Communication Speed
Specifies the communication speed for the parallel interface. If the communi-
cation speed is set too fast, data transfers may not flow smoothly. If this oc-
curs, change the setting to "Standard".
Note
Default: Standard
Selection Signal Status
Specifies the level for the select signal setting of the parallel interface.
Note
Default: High
Input Prime
Specifies whether the prime signal is active or inactive when an input prime
signal is sent. Under normal circumstances, you will not need to change this
setting.
Note
Default: Invalid
Bidirectional Communication
Specifies the printer's response mode etc., for status request when using the
parallel interface. If you experience problems when using other manufactur-
ers printers, set this to "Off". However, if this is set to "Off", asynchronous
functions will not work.
Note
Default: Yes
Signal Control
Specifies the error processing settings for when an error occurs when printing
from a computer or sending faxes. Under normal circumstances, you will not
need to change this setting.
Note
Default: Job acceptance priority
Settings You Can Change with the User Tools
3
43