4.1 OVERVIEW
This section describes the procedure for adjustments required when the printer is disassembled and
assembled for repair.
4.1.1 Required Adjustments
Table 4-1 lists all the adjustments required with this printer. If any service listed in this table is carried out,
all adjustments corresponding to that service should be performed to ensure proper operation of the
printer.
Performance Order
Service Performed
Replacing
the printer mechanism
Replacing
the C209 MAIN board
Replacing
the printhead unit
Replacing
the CR Motor
Replacing or disassembling
the carriage assembly
Replacing or disassembling
the PF Roller assembly
Note) "
":
Required adjustment
"NA":
Not applicable
4.1.2 Tools Required for Adjustment
Table 4-2 lists all the tools required to make the specified adjustments.
No.
Name
1
Thickness Gauge
2
Adjustment Program
Do not use rusty or deformed thickness gauge for adjustment.
Wipe off any dirt or dust from the thickness gauge before using.
Rev. A
Table 4-1. Required Adjustments
1
2
Paper-Gap
Ink
Adjustment
Charge
NA
NA
NA
NA
NA
NA
NA
Table 4-2. Required Tools
Adjustment
Paper-Gap Adjustment
Ink Charge
VH Setting
Head Angular
Bi-D Alignment
CAUTION
Chapter 4 Adjustment
3
4
VH
Head
Setting
Angular
Adjustment
NA
NA
NA
NA
NA
NA
Notes
Thickness:
1.04mm
EPSON Code: B776702201
Program Name:
5
Bi-D
Adjustment
NA
NA
K00A10VE.BAS
4-1