Pe Sensor Assembly Removal - Epson Stylus Photo Service Manual

EPSON Stylus Photo

3.2.5.8 PE Sensor Assembly Removal

1. Removing the upper housing. (Refer to section 3.2.1)
2. From the front side of the mechanism, unhook two hooks fixing "SENSOR, ASSEMBLY, PE" to the
mechanism. Then, slide it to upward to remove it. After removal, disassemble the assembly if
necessary.
When re-install the assembly, be sure that the sensor lever is correctly inserted into a hole of "PAPER
GUIDE, ASSEMBLY", UPPER".


Be careful not to damage the cable when inserting or pulling out it from the PE sensor board.


Make sure the sensor lever moves smoothly when installing it.
3-26
WORK POINT
Figure 3-24.PE Sensor Assembly Removal
CAUTION
Rev. A