Overview; Precautions For Disassembling The Printer - Epson Stylus Photo Service Manual

3.1 OVERVIEW

This section describes procedures for disassembling the main components of EPSON Stylus Photo.
Unless otherwise specified, disassembly units or components can be reassembled by reversing the
disassembly procedure. Therefore, no assembly procedures are included in this section. Precautions for
any disassembly or assembly procedure are described under the heading "WORK POINT". Any
adjustments required after disassembling the units are described under the heading "REQUIRED
ADJUSTMENT".

3.1.1 Precautions for Disassembling the Printer

See the precautions below when disassembling or assembling EPSON Stylus Photo.


Disconnect the power cable before disassembling or assembling the printer.


Wear protective goggles to protect your eyes from ink. If ink gets in your eye, flush the eye with
fresh water and see a doctor immediately.


If ink comes into contact with your skin, wash it off with soap and water. If irritation occurs, contact
a physician.


A lithium battery is installed on the main board of this printer. Be sure to observe the following
instructions when servicing the battery:

Keep the battery away from any metal or other batteries so that electrodes of the opposite
polarity do not come in contact with each other.

Do not heat the battery or put it near fire.

Do not solder on any part of the battery. (Doing so may result in leakage of electrolyte from the
battery, burning or explosion. The leakage may affect other devices close to the battery.)

Do not charge the battery. (An explosive may be generated inside the battery, and cause burning
or explosion.)

Do not dismantle the battery. (The gas inside the battery may hurt your throat. Leakage, burning
or explosion may also be resulted.)

Do not install the battery in the wrong direction. (This may cause burning or explosion.)
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacture. Dispose the used batteries according to government's law
and regulations.
Risque d'explosion si la pile est remplacée incorrectment. Ne remplacer que par une pile du même
type ou d'un type équivalent recommandé par le fabricant. Eliminer les piles déchargées selon les lois
et les règles de sécurité en vigueur.


Never remove the ink cartridge from the carriage unless manual specify to do so.


When transporting the printer after installing the ink cartridge, be sure to pack the printer for
transportation without removing the ink cartridge.


Use only recommended tools for disassembling, assembling or adjusting the printer.


Apply lubricants and adhesives as specified. (See Chapter 6 for details.)


Make the specified adjustments when you disassemble the printer. (See Chapter 4 for details.)
Rev. A
Chapter 3 Disassembly and Assembly
WARNING
CAUTION


CAUTION
3-1